Teledex B150D manual Desktop Installation, Wall Mounting

INSTALLATION

4) INSTALLATION

When installing your B150D, please select a location that is located near an unswitched AC outlet, near a modular phone line jack, and out of the way of activities that may interfere with the telephone’s operation.

CAUTION: You must use a Class 2 power source that supplies 12 volts AC, and delivers at least 500 mA. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the LCD display or the adapter.

4.1DESKTOP INSTALLATION

1)Plug one end of the handset coiled cord into the handset modular jack, located on the left side of the phone base. Plug the other end into the handset jack. (Refer to figure 2 below.)

2)Install wall mount bracket into four slots at the bottom of the B150D.

3)Plug one end of the thinner, four-conductorline cord into the jack labeled LINE on the power adapter. Plug the other end into a standard RJ-11 telephone wall jack. (Refer to figure 3 below.)

4)Plug one end of the thicker, six-conductorphone cord into the jack labeled PHONE on the power adapter. Plug the other end into the LINE jack at the bottom of the B150D. (Refer to figure 3 below.)

5)Plug the adapter into a standard AC wall outlet.

FIGURE 2

4.2WALL MOUNTING

1)Place the flat end of the wall mount bracket upward. Install the wall mount bracket into the four slots on the bottom of the B150D.

2)Follow steps #3 and #4 in section 4.1 Desktop Installation above for installation of line and phone cords. Route the adapter cord through the wall mount line cord slot.

3)Align the phone’s keyhole slots with the wall plate studs and slide the phone downward to secure it.

4)Plug the adapter into a standard AC outlet.

THINNER, 4-WIRE

LINE CORD

THICKER, 6-WIRE

PHONE CORD

FIGURE 3