RCA 2-9680 manual Appendix a Handset Sound Signals, Appendix B Troubleshooting Guide

Page 12

APPENDIX A: HANDSET SOUND SIGNALS

Signal

Meaning

Three long beeps

Page signal

A long warbling tone (with ringer on)

Signals an incoming call

Four short beeps

Out of range warning

 

 

APPENDIX B: TROUBLESHOOTING GUIDE

In case of difficulty, please check the following Troubleshooting Guide before seeking service.

Problem

Solution

No dial tone

• Check installation:

 

— Is the base power cord connected to a working

 

outlet?

 

— Is the Phone in Use light on?

 

— Is the telephone line cord connected to the base

 

unit and the wall jack?

 

• Disconnect the base from the wall jack and connect

 

another phone to the same jack. If there is no dial tone

 

in the second phone, the problem might be your

 

wiring or local service.

 

• Is the handset out of range of the base?

 

• Make sure the battery is properly charged (12 hours).

 

• Is the battery pack installed correctly? See page 8.

 

• Did the handset beep when you pressed the phone

 

button? Did the Phone in Use light come on? The

 

battery may need to be charged.

 

• Reset the security code by placing the handset in the

 

base for about 20 seconds.

 

 

10

Image 12
Contents Channel Cordless Telephone User’s Guide FCC Registration Information Table of Contents IntroductionGetting Started Before YOU BeginInstallation and Setup Cordless Phone Basics Making a CallReceiving a Call Volume Switch Ringer SwitchPaging the Handset Advanced Features Memory FeatureChannel Button Temporary Tone Changing the Battery General Product Care Appendix a Handset Sound Signals Appendix B Troubleshooting GuideProblemSolution Service Appendix C Causes of Poor ReceptionAccessory Order Form $9.95Accessory Order Form Index Warranty What will we do?