RCA 2-9398 manual Telephone Installation

Page 6

TELEPHONE INSTALLATION

DESK OR TABLETOP INSTALLATION

NOTE: Be sure to read the preceding pages for information about using the 9-volt battery backup before you begin the telephone installation.

4

2

3

1

1.Plug the handset cord into the handset and into the telephone jack on the left side of the unit.

2.Set the PULSE/TONE switch (located on the side of the unit) to TONE if you have touch-tone service; set it to PULSE if you have rotary service.

3.Plug the telephone line cord into a modular jack and into the PHONE LINE jack on the back of the unit.

4.Plug the power supply cord into the POWER 9V AC jack on the back of the unit, thread it through the strain relief, and then plug the adapter into an AC power outlet.

CAUTION: Use only the Thomson 5-2381 power supply that came with this unit. Using other adapters may seriously damage the unit.

4

Image 6

Contents Caller ID Telephone User’s Guide FCC Registration Information Interference InformationTable of Contents IntroductionGetting Started Before YOU BeginInstalling the Battery Telephone Installation Wall Mount Installation Setup Press the Store button Telephone Operation Speakerphone Location & USE GuidelinesSwitching Between Speaker and Handset Placing a CallReceiving a Call Adjusting Volumes Redial and Busy Redial FeatureBusy Redial Hold MuteDo not Disturb Temporary Tone Flash ButtonPause Button Using the Alarm Memory Dialing Storing a Number in MemoryImportant Call Indicator Storing the Last Number DialedStoring a Caller ID Number Reviewing and Deleting Stored Numbers Changing a Stored Number Dialing a Stored NumberDialing Longer Numbers from Memory Caller ID Operation Receiving and Storing CallsReviewing Messages Number of new callsDeleting Records Dialing a Caller ID NumberCalling Outside Your Area Code Message Indicators Data ErrorTroubleshooting Tips Telephone Service General Product CareIndex Limited Warranty For how long after your purchase