Wall Mount Installation

1.Rotate the handset hook.

2.Remove the base plate from the back by pressing down on the snap tabs located at the top, and then lifting the base plate off.

3.Plug the phone line cord into the phone jack on the back of the unit, wrap the extra line cord around the cord wrap on the bottom of the base, and then thread it through the bottom of the base plate.

4.Plug the power supply adapter into the POWER 9V AC jack on the back of the unit, and then thread it through the bottom of the base.

5.Reverse the direction of the base plate and replace it by putting the tabs into bottom slots in the middle of the unit first, and then snapping the bottom tabs into place.

6.Set the PULSE/TONE switch (located on the side of the unit) to TONE if you have touch- tone service; set it to PULSE if you have rotary service.

7.Connect the phone cord to the modular jack on the wall.

8.Slip the mounting holes over the wall plate posts and slide the unit down firmly into place. (Wall plate not included.)

9.Plug the handset cord into the handset and into the unit, and then hang up the handset.

10.Connect the AC Power supply adapter to an AC outlet.

1	9
2	10
3	11
4	12
5	13
6	14
7	15
	LOWER
8	16

THIS END UP FOR DESK USE

USE WALL FOR UP END THIS