Radio Shack ET-1755 owner manual 10#&5, 10#9#../2.#6

10"#"&'5-

1. Insert the mounting bracket’s four tabs into the slots on the bottom of the base then slide up to snap the mounting bracket into place.

2. If you have a two-line phone jack and a one-line phone jack, plug one end of the supplied two-line long modular cord into LINE L1/

L2 on the bottom of the base,

and plug one end of the supplied single-line long modular cord into L3. Then route both line cords through the left and middle slots on the mounting bracket.

If you have three single-line phone jacks, you can connect two lines with an optional two-line coupler. Plug one end of the two-line cord into LINE L1/L2, and the other end into the coupler’s jack. Then plug one end of the supplied long one-line cord into L3. Route both line cords through the left and middle slots on the mounting bracket.

3.Insert the supplied AC adapter’s barrel plug into AC 9V on the bottom of the base. Then route the adapter cord through the right slot on the mounting bracket.

4.Connect the other end(s) of the phone cord(s) to the phone line wall jack(s) and plug the adapter into a standard AC outlet.

10"#"9#../2.#6'

1.Place the flat end of the mounting bracket face up and insert the bracket’s four tabs into the matching slots on the bottom of the base. Then slide up and snap the bracket into place.

2.Insert the supplied AC adapter’s barrel plug into AC 9V, then route the adapter’s cord through the left slot on the mounting bracket.

3.If the wall plate has a single two-line phone jack, and there is a one-line phone jack nearby, plug one end of the supplied two-line short modular cord into LINE L1/ L2, and plug the one-line long modular cord into L3.

Then plug the two-line short modular cord’s other end into the two-line wall plate jack, and plug the single-line long cord’s other end into the one-line wall jack.

4