75+0)"*1.&
To put a call on hold, press HOLD. The line indicator flashes. You can then hang up the handset or use the other phone line (or answer another call, for example) without disconnecting the current call.
To resume the call, press that line’s button (LINE 1, LINE 2 or LINE 3) if the handset is not on the base. If the handset is placed on the base, lift the handset then press that line’s button. If you put a call on hold while using the speakerphone, press that line’s button. ±
75+0)"610'"5'48+%'5"10"#" 27.5'".+0'
Some special services, such as
1.Be sure TONE/PULSE is set to PULSE.
2.Call the service.
3.When the service answers, set ∗/TONE. Any additional numbers you dial are sent as tone signals.
After you complete the call and hang up, the phone automatically resets to pulse dialing.
/'/14;"&+#.+0)
You can store up to twenty phone numbers in memory, then easily dial a stored number. Each stored number can be up to 24 digits long, including tone and pause entries.
5614+0)"#"07/$'4"+0"/'/14;
Each of the phone’s ten memory locations can hold up to two phone numbers — one each in an upper and lower memory location. ±
1.Press STORE. The LOWER indicator flashes.
2.Enter the number and any tone or pause entries (see “Using Tone Services on a Pulse Line” and “Entering a Pause in a Memory Number” on Page 10).
3.Select the location where you want to store the number.
±"016'"±"
•You can put a call on hold at one extension and pick up the call at another extension.
•You can alternate between two lines by pressing HOLD to put your current line on hold, then pressing the button for the line you want to pick up.
•When a line on the main phone is on hold, that line is on hold on all extensions.
•When you put a call on hold and talk on the other line, the on- hold line beeps to remind you a line is still holding.
±"016'"±"
•You will hear a dial tone during most steps of this procedure. The phone does not actually dial the number as you store it, but you might also hear a busy tone or recorded operator’s voice after a few seconds. This is normal.
•To keep your accounts secure, we recommend you do not store your personal access code for services such as
•You can store phone numbers with the handset on or off the hook.
•Each pause entry counts as one memory digit.
•If you make a mistake while entering the number, start again at Step 1.
•To change a number in memory, store a new one in its place.
9