Changing the Remote Operation Security Code

43-733.fm Page 23 Friday, September 17, 1999 8:57 AM

Note: You can replay a deleted mes- sage by repeatedly pressing REPEAT on the base or REPEAT (4) on the handset before the TAD announces “End of mes- sages.”

To delete all played messages from a mailbox or the message center, press DELETE then the mailbox or message center button. The TAD beeps.

Note: You must play a message before you can delete it.

Note: If you do not begin entering the new code within 20 seconds, the TAD beeps and stops the process. If this happens, start over at Step 1.

3.Press REMOTE. The REMOTE indi- cator turns off.

To check the remote operation security code, press REMOTE then CODE. The TAD announces “Code is xx” and beeps twice.

CHANGING THE REMOTE

OPERATION SECURITY

CODE

To use your TAD from a remote tele- phone, you must first enter a 2-digit re- mote operation security code. The security code for your TAD is preset to

50.You can use the preset code, or fol- low these steps to change it.

1.Press REMOTE on the handset. The REMOTE indicator lights.

2.Press CHANGE () then CODE (7). The TAD announces “Enter new code.” Enter a new two-digit remote operation security code. The TAD announces “New code is xx” and beeps twice.