Radio Shack ET-1110 owner manual Setting the Dialing Mode, Selecting Language

43-1110.fm Page 15 Wednesday, August 18, 1999 8:22 AM

SETTING THE DIALING MODE

Set T/P (Tone/Pulse) on the back of the base for the type of service you have. If you are not sure which type you have, once the battery is fully charged, do this test.

1. Set T/P to T.

2.Lift the handset, then press TALK and listen for the dial tone.

3.Press any number other than 0.

Note: If your phone system requires that you dial an access code (9, for example) before you dial an outside number, do not press the access code either.

If the dial tone stops, you have touch-tone service. Leave T/P set to

T.

If the dial tone continues, you have pulse service. Set T/P to P.

SELECTING THE

LANGUAGE

The ET-1110 comes set to display all Caller ID messages in English, but if you want it to display messages in French or Spanish, follow these steps.

1.Press SETUP on the handset. Lan- guage and the currently selected language appear.

Note: If you do not press any key within 15 seconds after the lan- guage selection display appears, the ET-1110 exits the language se- lection display without changing the current selection.

2.To select another language, repeat- edly press / or /# until you see the desired language.

3.Press SETUP to store the selected language.

15