Using a Headset, Removing the Belt Clip

43-1110.fm Page 27 Wednesday, August 18, 1999 8:22 AM

USING A HEADSET

You can make or answer calls with hands-free convenience using an option- al headset that has a 3/32-inch (2.5 mm) plug. We recommend RadioShack Cat. No. 43-195 (not supplied), which is spe- cially designed for use with the ET-1110.

Follow these steps to use a headset.

1.Insert the headset’s plug into the jack on the top of the handset.

2.Place the headset on your head with the earpiece over either ear and ad- just the microphone boom until it is about even with your chin.

3.Hang the belt blip on your belt.

4.Make or receive calls as you would normally.

Notes:

•Connecting a headset disconnects the handset’s earpiece and micro- phone.

•If you place the handset on the base to recharge it while the headset is connected, be sure the handset seats properly.

REMOVING THE BELT CLIP

The belt clip on the back of the handset lets you hang on the belt for easy porta- bility. But to use the hanging hole on the back of the handset to place the handset on the wall-mounted base face-up, you must remove the belt clip.

Insert a flat-blade screwdriver into either side of the belt clip, then pull off it.

To replace the belt clip, insert either tab of the belt clip into one slot of the hand- set, then snap the other tab into other slot of the handset.