Radio Shack owner manual Editing or Deleting a Number in Memory, ∗ ç ¶ý& âýá space &ý

1.Lift the handset.

2.Hold down MEM until C[ceho Ijeh[ and a list of memory location numbers appear.

3.Press the appropriate numbers to choose the desired two-digit memory location (01–20). Precede a single digit location number with 0 (01, 02, 03, and so on).

4.Press SELECT. Ijeh[ý DWc[ appears. If you do not want to enter a name, skip to Step 6.

5.To enter a name, use the number keys.

Refer to the letters on the number keys to select the desired letter. Press the key once for the first letter in upper case, press twice for the second letter in upper case, and so on. To enter a lower case letter, press four times (or five times) to display the first letter in lower case, five or six times for the second letter, and so on.

For example, to enter John: press 5 once; upper case @ appears. Then press 6 six times; lower case e appears. Press 4 five times; lower case ^ appears. Finally, press 6 five times; lower case d appears.

To enter two letters from the same key in a row, press FLASH/7 to move the cur- sor to the next position. For example, to

enter AB, press 2; 7 appears. Then press FLASH/7, the cursor moves to the next position, then press 2 twice so 8 appears.

To enter a space, press FLASH/7 twice without entering any character.

To enter a number, repeatedly press the corresponding number key until the number appears.

To enter a special character, use 0. Each time you press 0, the following charac- ters appear in this order:

∗ç ¶ý& âýá (space) &ý

If you make a mistake, use REDIAL/6 or FLASH/7 to move the cursor over the error, then enter the correct charac- ter, or press DELETE/CH to delete a character. To delete all characters, hold down DELETE/CH for at least 1 second.

6.Press SELECT. Ijeh[ýDkcX[h appears.

7.Enter the phone number and any tone or pause entries.

8.Press SELECT. The phone beeps and

C[cehoddýIjeh[Z (dd is the memory loca- tion number) appears.

After 2 seconds, C[cehoýIjeh[ appears. Repeat Steps 3–8 to store more num- bers.

9.When you finish, press MEM.

Note: To replace a stored number, store a new one in its place.

Editing or Deleting a Number in Memory

1.Lift the handset.

2.Hold down MEM until C[cehoýIjeh[ and a list of memory location numbers appear.

3.Choose a memory location (01–20) by

pressing a number or by repeatedly pressing VOL/CID 8 or 9.

4.Press SELECT. A menu appears with the following three options.

;Z_jý C[cehodd — edit the record as described in Steps 5 through 8 of “Stor- ing a Name and Number in Memory” on Page 16.

Telephone Operation 17