Radio Shack ET-905 owner manual Replacing the Handset Battery

Page 17

43-1080.fm Page 17 Tuesday, August 17, 1999 1:51 PM

REPLACING THE HANDSET BATTERY

When the handset’s battery no long- er recharges, replace the battery. Use only a 3.6V, 650 mA battery with a connector that fits the connector in the battery compartment. You can order a replacement battery from your local Radio Shack store.

1.Press down on top of the hand- set’s battery compartment cover (on the three raised bars on the lower back) and slide it off.

2.Using a Phillips screwdriver, turn the stainless steel strap’s screw counterclockwise to loosen it slightly.

3.Turn the steel strap clockwise and pull back to release it.

4.Remove the battery pack and pry out the battery wires’ plug using a small flat-blade screw- driver.

5.Insert the new battery pack’s plug into the receptacle and firmly push down to make sure it is properly connected.

6.Insert the steel strap’s hooked end into the slot beside the bat- tery connector and hold it up while you place the new battery pack in the compartment.

17

Image 17
Contents ET-905 Features Read this Before Installation FCC Statement Contents Selecting a Location InstallationSetup on a Desktop Mounting Directly on a Wall Preparation Charging the HANDSET’S BatterySetting the PULSE/ Tone Switch Setting the RINGER’S Sound LevelUsing Flash Using RedialOperation ANSWERING/MAKING a CallUsing Tone Services on a Pulse Line Using PrivacyUsing Direct Dialing Storing a Number Memory Memory OperationDialing a Stored Number UsingStoring a Pause in Memory Troubleshooting Tone Cause Remedy Alert TonesMaintenance Replacing the Handset Battery FCC Wants YOU to Know Lightning Radio Shack