Radio Shack ET-689 owner manual Memory Dialing, Paging, Storing a Number in Memory

43-689.fm Page 16 Thursday, September 16, 1999 10:22 AM

USING TONE SERVICES ON A PULSE LINE

Some special services, such as bank- by-phone, require tone signals. If you have pulse service, you can still use these special tone services by following these steps.

1.Be sure T/P is set to P.

2.Dial the service’s main number.

3.When the service answers, press

. Any additional numbers you dial are sent as tone signals.

If you hold down PAGE for 2 seconds, the handset beeps for 3 minutes to give you more time to locate it. To stop it sooner, press PAGE once or either line button twice.

MEMORY DIALING

You can store up to 20 numbers, then dial any of the stored numbers by press- ing a two-digit memory location number.

Each stored number can be up to 24 digits long.

4.After you complete the call, return the handset to the base or press the button for the line you were using. The phone automatically resets to the pulse mode.

PAGING

To locate the handset when the phone is not in use, press PAGE on the base. The handset beeps three times.

16

Storing a Number in Memory

Note: If you wait more than 20 seconds between each key press, an error tone sounds and the phone exits the storing mode.

1.Press MEM on the handset. The LINE 1 indicator flashes.