Radio Shack ET-689 owner manual Mounting the Phone, On a Desk Top

43-689.fm Page 7 Thursday, September 16, 1999 10:22 AM

MOUNTING THE PHONE

On a Desk Top

1.Remove the base’s bracket by pressing both tabs on the wide end, then lifting off the bracket.

2.If you have a single 2-line modular jack, plug one end of the supplied 2- line long modular cord into L1 OR L1/ L2 on the back of the phone’s base.

Note: When you make this connec- tion, do not connect another modu- lar cord to the L2 jack. Otherwise, the phone will not operate properly.

If you have two separate 1-line mod- ular jacks, plug one end of the sup- plied 2-line long modular cord into L1 OR L1/L2 and plug the other sup-

plied 2-line long modular cord into L2.

If you have a single 1-line modular jack, plug one end of either supplied long modular cord into L1 OR L1/L2 to use line 1, or into L2 to use line 2.

3.Plug the supplied AC adapter’s bar- rel plug into the DC 12V jack on the back of the phone’s base.

4.Route the adapter’s cord through the right groove on the bottom of the base.

7