Radio Shack ET-551 owner manual Placing the Base on a Desk Top, Mounting the Base on a Wall Plate

Page 6

43-1051.fm Page 6 Tuesday, August 17, 1999 1:08 PM

Placing the Base on a Desk Top

Follow these steps when you place the base on a desk, shelf, or table.

1.Plug one end of the supplied long modular cord into the LINE jack on the back of the base.

4.Plug the adapter into a standard AC outlet.

5.Plug the modular cord’s other end into a modular phone line jack.

 

DC12V

LINE

T P

 

 

2. Insert the supplied power adapter’s barrel plug into the DC

12V jack on the back of the base.

6. Fully extend the base’s antenna and place it in a vertical position.

 

DC12V

LINE

T P

 

3.Route the adapter’s cord through the strain relief slot on top of the base.

Strain Relief Slot

Mounting the Base on a Wall Plate

1.Plug one end of the supplied short modular cord into the LINE jack on the back of the base.

 

DC12V

LINE

T P

 

 

 

6

Image 6
Contents ET-551 Features Read this Before Installation FCC StatementContents Installation Installing the HANDSET’S AntennaSelecting a Location Placing the Base on a Desk Top Mounting the Base on a Wall PlateStrain Relief Slot Groove Mounting the Base Directly on the Wall Connecting and Charging the Battery Pack Charge Indicator Setting the Dialing Mode Setting the VolumeTurning the Ringer on or OFF Making and Receiving Calls Using RedialOperation Changing ChannelUsing Flash Using Tone Services on a Pulse LinePaging Memory DialingStoring a Number in Memory Entering a Pause Chain-Dialing Service NumbersTesting Stored Emergency Numbers Dialing a Memory NumberTroubleshooting Fm Page 17 Tuesday, August 17, 1999 108 PM Care and Maintenance Replacing Battery Pack FCC Wants YOU to Know Lightning Fm Page 22 Tuesday, August 17, 1999 108 PM Fm Page 23 Tuesday, August 17, 1999 108 PM RadioShack Division of Tandy Corporation Fort Worth, Texas