Radio Shack ET-545 Entering a Pause A Memory Number, Reviewing Numbers Stored in Memory

43-1045.fm Page 15 Tuesday, August 17, 1999 10:58 AM

Entering a Pause

in a Memory Number

In some telephone systems, you must dial an access code (9, for example) and wait for a second dial tone before you can dial an outside number. If your phone is connected to one of these systems, you might want to en- ter a pause after the access code when you store a phone number in memory.

At the appropriate place in the num- ber, press REDIAL/PAUSE to enter a 2-second pause. P appears. For a longer pause, press REDIAL/PAUSE again.

illus

Note: Each REDIAL/PAUSE entry uses one digit of memory.

Reviewing Numbers Stored in Memory

Press MEMORY, then enter the num- ber of the memory location to display the stored number.

You can also review the information stored in memory by pressing MEMO- RY, then REVIEW < or >.

illus

Dialing a Stored Number

There are two ways to dial a stored number.

Method 1

1.Lift the handset and press TALK. The keypad and TALK key light.

2.When you hear a dial tone, press MEMORY and then press the cor- rect 2-digit memory location num- ber. The memory location number and the stored number appear on the display, and the phone dials the stored number.

Method 2

1.Lift the handset and press MEM- ORY. MEMO #00 appears on the display.

2.Press REVIEW < or > to search for the desired stored number or press the 2-digit memory location number. The memory location number, the name, and the phone number appear on the display.

15