4.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.
Tabs
Lower
Tab
Slots
5.Route the adapter’s cord through the strain relief slot on the bracket.
Strain
Relief Slot
6.Plug the adapter into a standard AC outlet.
7.Lift the base’s antenna to a vertical position.
On a Wall Plate
1.Insert the bracket’s tabs into the base’s lower tab slots as shown, then press down on the bracket’s clips and insert them into the clip slots.
Clip Slots
2.Plug one end of the supplied short modular cord into the TEL LINE jack on the back of the base.
3.Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base.
4.Route the adapter’s cord through the narrow groove on the bottom of the bracket.
Narrow
Groove
7