ON A DESK TOP
1.Plug one end of the supplied long modular cord into the TEL LINE jack on the back of the base.
DC IN 9V TEL LINE
2. Insert the supplied AC adapter’s barrel plug into the DC IN 9V jack on the back of the base and route the adapter’s cord through the strain relief slot on the base.
3.Plug the other end of the modular cord into a modular phone line jack.
4.Plug the adapter into a standard AC outlet.
ON A WALL PLATE OR WALL
To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the base.
Drill two holes 315/16 inches apart. Thread a screw into each hole, letting the heads extend about 1/8 inch.
1. Insert the two
of upper tabs of the supplied
bracket into the base’s
upper tab
slots. Then slide down the bracket so that two of the lower tabs would be inserted into the lower slots.
CAUTION
You must use
!a Class 2 power source that supplies
9V DC and delivers at least 210 mA. Its center tip must be set to positive and its plug must fit the phone’s DC IN 9V jack. The supplied adapter meets these specifications. Using an adapter that does not meet these specifications could damage the phone or the adapter.
Installation
9