Mounting the Phone, Using the Phone | Radio Shack ET-238 specification

MOUNTING THE PHONE

Desk Mounting	Wall Mounting
	(With Wall Plate)

USING THE PHONE

Switch to TONE or PULSE to match the type of service you have. If you have pulse (rotary) service, you can

switch to TONE during a call to use tone services.

Press for special services.

Use the memory index card to record important phone numbers.

	Modular	Short
		Line
	Telephone
		Cord
	Jack
		(Not

		Supplied)

Wall Mounting

(Without Wall Plate)

Handset Holder

(Wall Mounting)

1. Pull out.

2. Rotate 180°.

Press STORE once to enter the telephone	Press to disconnect a call.
number you wish to store. See “Storing/Dial-
ing Numbers in Memory.”
Press PAUSE to enter a pause for systems
that require an access code (9, for example)
before you can dial an outside number.
Press MEMORY once to enter the
two-digit location (01-20) for the
number you want to store or to dial
the number in memory. See “Stor-
ing/Dialing Numbers in Memory.”	Set the ringer to sound or not.
	Set the ringer to sound or not.
	You can make and receive calls
	with the ringer off.

	Press FLASH in place of the switchook for
	special services such as call waiting.
	Press RESET to end a call without returning the
	handset to the cradle.
Plug the handset cord into the jacks on	Press REDIAL to dial the last number dialed
the handset and base.	(up to 31 tone or 32 pulse digits).

STORING/DIALING NUMBERS IN MEMORY

Note: The phone company can charge you for the instal- lation of the necessary jacks. The USOC number of the jacks to be installed is RJ11C (RJ11W for a wall jack).

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol is intended to alert you that parts inside the telephone present a risk of electric shock.

To store a number in memory:

1.Lift the handset.

2.Press STORE.

3.Enter the telephone number you want to store. Note: A pause entry counts as 1 digit.

4.Press MEMORY once.

5.Enter the 2-digit number (01-20) for the location where you want to store the number.

6.Repeat Steps 3-5 to store additional numbers. Return the handset to the cradle when you finish storing numbers.

To dial a number in memory:

1.Lift the handset.

2.Press MEMORY.

3.Enter the two-digit location number for the number you want to call.

This symbol is intended to alert you to important operating and servicing instructions included in the papers with the telephone.

ã ÐÐ

1994 Tandy Corporation.

Radio Shack is a registered trademark used by Tandy Corporation.