GE 2-9926 manual Each Line on a Separate Modular Jack

Page 7

6

3

7

 

 

5

1

2 T/P switch

Each Line on a Separate Modular Jack

1.Make sure base plate is securely fastened.

2.Set the T/P switch to T for touch-tone service, or P for pulse (rotary) service. If you don’t know which type of service you have, check with the phone company.

3.Raise the base antenna.

4.Set the RING switch to ON so the handset rings for incoming calls.

5.Plug one of the telephone line cords into the L2 jack and into a single line modular jack. Connect the remaining phone cord to the L1 and L2 phone jack located on the back of the phone and into a single line modular jack.

6.Plug the power supply cord into the base and into an AC outlet.

7.Place handset in the base to charge for 12 hours. The CHARGE/PAGE light comes on indicating that the battery is charging. If you don’t

charge the handset battery properly (for 12 hours) when you first the phone, the battery’s long-term performance will be compromise

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 900MHz Two-Line Cordless Telephone with Headset User’s Guide FCC Registration Information Introduction Table of ContentsBefore YOU Begin Getting StartedTwo Lines on Single Modular Jack Installation OptionsTwo Lines on a Single Modular Jack Desktop InstallationEach Line on a Separate Modular Jack Wall Mount Installation Each Line on a Separate Modular Jack Making a Call Cordless Phone BasicsFlash Button Receiving a CallVOL switch on the side of the handset VOL Volume SwitchTemporary Tone Mute ButtonConference Button Hold ButtonPaging the Handset Memory Feature Advanced FeaturesChannel Button Chan Changing a Stored Number Number For Memory Location Connecting the Belt Clip Connecting a Headset to HandsetHeadset and Belt Clip Operation Changing the Battery Problem Solution Troubleshooting GuideCannot hear Causes of Poor Reception General Product CareService Description Accessory Order FormRedial Tone IndexFor how long after your purchase Limited Warranty
Top Page Image Contents