IN CASE OF DIFFICULTY
in case of difficulty,
PROBLEM
No Dial Tone
.
Dial Tone but can’t dial out
Handset does not ring
check the Troubleshooting Chart below before swking semice.
1.Check Installation:
—IS B~S~ POW~~ CORD connected to a working outlet?
—Oo not use an outlet that can be turned ON and OFF by a wall
switch.
—IS T~~~P~O~~ ~1~~ CO~~ connected firmly to the base unit and phone outlet?
—Is BASE ANTENNA raised?
2.Is CO~O~~SS HANDSET out of range of the base?
3, Make sure BA~ER/ES are properly charged (12 Hours).
4.Is the B~TT~~Y PACK installed correctly (see page 19)?
5.Did the CORDLESS HANDSET beep when YOU pressed the phone button? Did the phone light come on? If not, your cordless may need to be, charged.
6.Disconnect CORDLESS PHONE and connect another phone to the same jack. If no dial tone, then the problem may be in your wiring or local sewice.
7.Reset security code by placing handset in base unit. (see page 9)
8.If you have pulse sewice on your line, your TONE/PULSE Switch on the Base must be set on Pulse.
9.Make sure R/NGER Switch on Handset is “ON”.
10.Do you have too many extension phones on your telephone line? Try
unplugging some other phones. “
11. Perform checks 1,2,3,4,5,6 and 7 above.
. .
. .
You experience static, noise, or fading in and out
12. | TV changing the channel. (see page 14) |
13. | Is BASE ANTENNA raised? |
..
-
Unit beeps
Memory Dialing Problems
14. Is HANDSET out of range from the BASE? Move closer to BASE. | ||||
15. Does the BASE need to be relocahd? | ||||
16. Is CORDLESS BASE plugged into an outlet with household | ||||
| appliances? If so, move the appliance or telephone. | |||
17. | Check | installation | per #1 above. | |
18. | Charge | 8A~ERY | for 12 hours. | |
19. | Clean charging contacts | on HANDSET and BASE with a soft cloth. | ||
20. | Check | installation | per #l | above. |
21. | ~epiace BATTERY. |
| ||
22- Did you program the memory correctly (see page 17)?
23.Did you follow proper dialing sequence (see page 17)?
24.See #8 above.
25.Oid you reprogram numbers into memory after power outage? (See Page 17)
21
..