GE 2900SST important safety instructions Desktop Installation

Page 7

DESKTOP

6

INSTALLATION

1

5

2

4 Ringer volume switch

3 PULSE/TONE switch

1.Plug the telephone line cord into the base and into a modular jack.

2.Plug the power supply cord into the base and into an AC outlet.

3.Set the PULSE/TONE switch to TONE for touch-tone service, or PULSE for rotary service. If you don’t know which type of service you have, check with the phone company.

4.Select either OFF, LO, or HI (on the base) for the preferred ringer volume. If you select OFF, the handset will not ring with incoming calls or paging, but theTALK button will light.

5.Raise the base antenna.

6.Place handset in the base to charge for 8 hours. The CHARGE light comes on indicating that the battery is charging. A low battery warning (BATT LOW light and warning tone) will remind you to charge the handset batteries for at least 8 hours.

NOTE: Use only the Thomson 5-2387 power supply that came with this unit. Using other adapters may damage the unit.

7

Image 7
Contents Important Safety Instructions To Rain or Moisture Introduction Table of Contents Before YOU Begin Getting StartedHandset Setup Desktop Installation Plug one end of the short telephone Wall Mount InstallationMaking a Call Cordless Phone BasicsReceiving a Call Flash Button Volume Button VOLMute Button Paging the Handset Temporary ToneMemory Feature Advanced FeaturesChannel Button Chan Storing a Redial Number Changing the Battery Battery Safety Precautions Wall jack? Troubleshooting GuideYou are receiving an out-of-range alert, move closer General Product Care Handset Sound SignalsInterference Information Causes of Poor ReceptionLoad Number Telephone Network InformationMute PAGE/FIND Redial Tone IndexPurchase Date Name of Store Service