GE 28321EE1 manual Caller ID Solutions, No Display Charge or replace the batteries

16Other Information

Unit beeps

•Clean charging contacts on cordless handset.

•See solutions for “No dial tone”.

•Replace the battery.

Memory Dialing doesn’t work

•Did you program correctly?

•Did you follow proper dialing sequence?

Handset displays "SEARCHING" or "NOT REGISTERED" and cannot link up with the base when the TALK/CALL BACK button is pressed.

•Handset may be out of range of the base. Move closer to the base.

•Make sure the power adaptor is properly installed.

•Disconnect the handset battery and plug it in again. Place the handset on the cradle for at least 2 to 3 minutes.

•Disconnect the power adaptor and plug it in again. Then place the handset on the cradle for at least 2 to 3 minutes.

Handset displays "NOT REGISTERED"

•Follow the programming in the telephone procedures to re-register the handset to the base.

•Press the SELECT button to begin handset registration. Follow instructions on Handset screen.

Registration did not work

•Charge the batteries for 16 hours.

•Uplug and then plug in the power adaptor.

Caller ID Solutions

No Display

•Charge or replace the batteries.

•Make sure that the unit is connected to a non-switched electrical outlet. Disconnect the AC power adaptor from the base and reconnect it.

Caller ID Error Message

•The unit displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring.