GE 29484GE2 manual Memory, Storing a Number, Changing a Stored Number

Memory

Each of the 8 memory buttons has the capability of storing 2 separate telephone numbers (up to 32 digits each). Each memory button accesses an upper and a lower memory location. The LOWER button accesses those numbers stored in the lower memory locations. You can program the memory when the unit is idle or when you are using the phone.

Storing a Number

1.Press the STORE button. The red indicator blinks indicating the unit is in Store Mode.

2.Enter the phone number you want to store using the keypad digits.

3.Press STORE again.

4.Press the memory location button (1-8) where you want to store the number. If you want to store it in upper memory, simply press the memory location button. If you want to store it in lower memory, press the LOWER button. The red indicator stays on. Press the memory location button where you want to store the number.

5.For future reference, you may want to write the name or number of the party you have stored in this location in the corresponding space on the memory index card.

6.Repeat steps 1-5 for any additional numbers you want to store, up to a total of 16.

7.To cancel the storing procedure at any time, press STORE twice or place the handset on the cradle.

NOTE: The storage procedure will automatically cancel after 15 seconds if no keys are pressed. Also, when pulse mode is used, pressing the TONE* key before programming will store all digits in tone.

Changing a Stored Number

If you want to change the stored number, simply enter the new number over the old number using the previous memory storing procedure. To erase a stored number, press STORE twice, then the memory location you want to erase.

18