Requirements, DPH-10U Installation

3. Requirements

In order to install the DPH-10U VoIP USB Phone you will need the following:

1.DPH-10U VoIP USB Phone

2.PC with the following minimum specifications: o Pentium 400MHz or equivalent

o Windows 2000 or XP

o Available USB port (1.0, 1.1 or 2.0)

o Skype™ version 1.1.079 or higher (www.skype.com) must be installed o 128MB RAM

o 10MB available hard disk space

o CD-ROM drive to install DPH-10U software from the supplied

CD-ROM

4. DPH-10U Installation

The following instructions will guide you to through the process of installing the DPH-10U VoIP USB Phone.

The installation procedure is to:

•Install Skype™ (step 1 below)

•Plug in the DPH-10U WHEN INSTRUCTED TO DO SO (step 2 below)

•Start the DPH-10U software installation (step 3 below)

•Following the installation is OK (step 3 below)

•Use your DPH-10U to make Skype™ calls

The detailed instructions follow:

STEP 1: If Skype™ is not already installed on your computer, visit http://www.skype.com and follow the instructions there to install Skype™. Verify that Skype™ is working before installing the DPH-10U.

STEP 2: Connect the DPH-10U USB port as shown below.

You will see the following popup. Press Yes to proceed or No to cancel.

Connect to PC

Connect to NB