PIR settings (figure 1)
The jumpers settings are as follows:
Range: | |
| Medium- 50 feet |
| Low- 30 feet |
LED: | ON- led will flash when it detects |
| OFF- led is always dark |
Filter: | On- set for outdoor use |
| |
Reset: | 15 seconds to reset after activation |
| 120 seconds to reset after activation |
Coding the transmitter:
Note: The transmitters and receivers are preset at the factory. DO NOT change settings, unless changing the tune or experiencing false sig- nals.
1.When looking at the PIR you will see clips on the sides of the plastic case. Push one of the clips away from the center of the case and lift out the PIR and theplasticbacking.Youwillnowbelookinginsideof the case at the radio transmitter (figure 2)
Figure 1
PIR with cover removed
3.