Dakota Alert Dakota Alert,Inc. Wireless Rubber Hose Transmitter, DCHT-2500 Coding the transmitter

Operation: (Always test unit prior to installation) The control box is powered by one 9-volt battery.

Coding the transmitter:

Note: The transmitters and receivers are preset at the factory. DO NOT change settings, unless changing the tune or experiencing false signals.

1.Open the transmitter box.The first thing you will see is the air switch (Figure 2). Directly below the air switch is the transmitter’s radio (Figure 3).

2.Locate the dip switches on the radio (2)(3).

3.Switches 1-8 are for the frequency setting (256 combinations). If needed, set switches 1-8 (2) to match the eight switches in the receiver.

4.Switches 9 and 10 (3) are for the channel setting on the transmitter. Use these to set the tone you prefer. The four channels are listed in the table on page 5.

3+

feet

figure 1

3.