Table to select tones:
Switch 9 | Switch 10 | Channel | Tune |
|
|
|
|
On | On | 1 | Classical |
|
|
|
|
Off | On | 2 | Westminster |
|
|
|
|
On | Off | 3 | Ding Dong |
|
|
|
|
Off | Off | 4 | Whistle |
|
|
|
|
Coding the receiver:
1.Open the receiver case by inserting a small screwdriver into one of the pry notches on the side of the case. (refer to receiver manual)
2.Gently lift off the front cover.
3.Locate the eight dip switches on the receiver and make sure they are set identically to dip switches
Note: If more than one transmitter is used with the receiver, the first eight dip switches of all transmitters must match the eight dip switches of the receiver.
Note: Whenever a change is made to any jumper or the dip switches, the receiver must be turned OFF and then back ON to operate properly.
Frequency: 433.92 MHz
Operating range:
Battery life:
LOW BATTERY ALERT: If the receiver sounds a second alert 30 seconds after the first alert, provided nothing trips the transmitter again, the
5.