Siemens Giga 3000 operating instructions Registering the handset

Page 9

Giga 3000 Comfort, IM1-engl, A31008-G3000-B002-3-6Z19 3000co.fm

05.01.00

Registering the handset

You can change the display language (see page 21). After doing this, switch your handset off and then on again.

You must register a new handset at the base station before you can make any telephone calls. When you switch on your handset, the message 5HJLVWHU"* appears.

Step 1:

• You must first prepare the Siemens base station:

Gigaset

Preparing the base station

 

 

3010/pocket

Press the coloured key on the base station

3015

for approx. 10 seconds until you hear the

 

signal tones.

 

 

3020, 3025

In the base station menu select registration

3030, 3035

option and confirm.

 

 

ISDN

Press the LED – flashes during registration.

models

 

 

 

1000/2000

See above for appropriate successor models

models

in the 3000 range, e.g. 3010 for 2010.

 

 

Step 2:

Now enter the following in the handset within one minute:

<(6

Press the display key.

Enter base PIN

Enter the base station’s system PIN (fac-

Ö2.Ö

tory setting: 0000) and confirm – unas-

 

signed internal numbers are displayed.

e.g. s

Enter the required call number – the base

 

name, e.g. %DVH, is displayed (no

 

longer flashing).

 

Your handset is now ready for use!

To register at multiple base stations or to change base names, see page 23.

To modify the internal call number: re-register your hand- set at the same base, see page 23.

*English is the default factory setting

9

Image 9
Contents Gigaset Comfort Brief overview Idle display, display keysProtective film Important menus Safety precautions Display symbolsÖ2. Contents Contents of the package Preparing the handsetInserting the batteries Approved batteries Charging the batteriesActivating/deactivating the handset Fitting the attachment clipActivating/deactivating keypad protection Handset operating time/charging timeRegistering the handset Making external calls Making callsDirect internal dialling Answering a callWhen the user answers Handsfree talking when dialling/answering a callHandsfree talking Transferring a call, making an enquiry callManual redial RedialAutomatic redial Additional functionsStoring a call number DirectoriesDialling from the directory Ö2.ÖPress the appropriate key repeatedly or hold it down Entering namesControlling the cursor Deleting a characterHandset called rings RS\QWU\Network access support Speed dialling from the network access listLinking call numbers Handset/loudspeaker volume Audio settingsÖ2.Ö Change the volume and save Caller listSetting short beeps advisory beep Ringer volume/melodyActivating/deactivating warning and signal beeps Select the required functionChanging the telephone PIN SecuritySecurity functions begin as follows Ö2.Ö Ö2.ÖHot key selection direct station selection Safety preTelephone lock Saving/changing/deleting a hot key numberSetting the display language Further settingsDialling the emergency number Auto talkHandset factory settings Resetting the handset to the default configu- rationAdditional base settings Base settingsAll other base settings begin as follows Registering the handsetBase station user options Handset user options handset short cutsSaving handset user options Starting a handset short cut QVHUWXQFWLRQRoom monitor Setting the noise levelSaving the call number Activating the room monitorGuarantee/service Settings at the baseAppendix Range