Cobra Electronics CP-2525 About Cordless Phone Performance, Replacing the Handset Battery

Page 11

REPLACING THE HANDSET BATTERY

The rechargeable NiCad battery in your cordless phone may need to be replaced if the handset will not function when the TALK button is pressed after recharging for 12 hours.

Replacement batteries are available direct from Cobra (see accessories order form at the end of this booklet or call 1-773-889-3087).

1.To remove the battery door, press and slide downward.

2. Carefully disconnect the battery pack and dispose of it properly. See BATTERY DISPOSAL below.

3. To replace, observe connection orientation and connect the new battery and replace the door. Return the handset to the base and charge the battery overnight (at least 12 hours).

HANDSET BATTERY DISPOSAL

The rechargeable nickel cadmium (NiCad) battery in this product must be recycled or disposed of properly in compliance with all applicable laws. It may not be thrown in the trash. Certain states or municipalities require recycling and have established collection programs. Please contact your local waste removal authority for instructions, or return to Cobra for recycling. Wrap batteries carefully and mail postage prepaid to: Cobra Electronics Corporation, 6500 W.

Cortland Street, Chicago, Illinois 60707, Attn: Battery Recycling.

Or contact the Rechargeable Battery Recycling Corporation (RBRC) at 1-800-8BATTERY for a local recycling center near you. For more information about battery recycling, the RBRC has a web site at: http://www.RBRC.com

DO NOT PUT BATTERIES INTO

FIRE OR EXPOSE TO HIGH HEAT.

THEY MAY EXPLODE.

CLEANING THE CHARGING CONTACTS

Clean the two metal charging contacts on the base and handset with a soft dry cloth on a regular basis to ensure optimum performance of the battery-charging system. Rubbing alcohol may be used if more thorough cleaning is required.

19

About Cordless Phone Performance

Your Cobra Intenna cordless phone uses radio transmission to communicate between the base and handset. It is thus subject to occasional interferenceÑstatic or buzzing noises, for example. These conditions may be caused by electrical motors on household appliances, ßuorescent lights, electrical storms and other sources.

These steps will enhance the maximum performance of your new phone:

Change channels by pressing the CHANNEL button on the handset if you experience interference.

Don’t cover the upper section of the cordless handset with your hand (see diagram below). This may block the internal antenna located at the top of the handset, possibly reducing the phoneÕs range and audio clarity. Always hold the handset at the middle or close to the bottom

Hold the cordless

handset at the middle or bottom area of your phone for best performance and range.

INCORRECT CORRECT

Avoid resting the handset on your shoulder during conversations; this may also block the performance of the internal antenna.

Avoid plugging your phone’s power cord into an active AC outlet that also provides power for a major appliance or for charging units a for cordless appliances (vacuums, screwdrivers, etc.) or other electronic devices.

20

Image 11
Contents Cordless Telephone With Caller ID Cordless Telephone Model CP-2525 Table of Contents Important Safety Instructions Introduction Installation InformationWall Mounting Instructions Quick Set-Up GuideCordless Phone Operational Features Using Your PhoneDeleting AN Entry in the Caller ID LOG Caller ID CONT’D Caller ID LOGMaking a Call from the Caller ID LOG Special Calling Situations Electronic Directory CONT‘D Electronic DirectorySystem FindFlash Hearing AID CompatibilityRechargeable Handset Battery Information About Cordless Phone Performance Replacing the Handset BatteryHandset Battery Disposal Cleaning the Charging ContactsRegistered with the FCC Cordless Telephone Troubleshooting GuideIf YOU Think YOU Need Service Call Cobra Electronics Corporation Limited One-Year WarrantyCobra Cordless Phone Accessories