BT 3000 Classic manual No dial tone

Page 48

Diverse 3000 H_set & Charger 22/3/01 1:55 pm Page 44

Diverse 3000 ~ Edition 7 ~ 28th February ’01 ~ 3723

BT accepts no responsibility for damage caused to your Diverse 3000 Classic Handset and Charger by the use of non-approved batteries.

No display appears

Is the handset switched on? The battery may be flat or dead. Recharge or replace the battery.

No dial tone

Is the telephone line cord plugged into the phone socket and the base station?

Please note

If you go out of range of a base station for a long time while your handset is switched ON, it may take more than 20 minutes to ‘find’ the base station again when you come back within range. However, by simply switching the handset OFF for a moment, and then ON again, it will find the base station within a few seconds.

The handset does not ring

If other handsets are registered on the base, the outside line may already be in use. Wait until the call is finished and try again.

The base station is flashing or you cannot link up with the base station

Is the handset registered with the base station? To register the handset, see page 10. Is the power cable connected at the base and the power switched on at the wall socket?

If you press the PHONE button

whilst is flashing, you will hear four short beeps from the handset.

The ringer volume may be set too low, or switched off at the base station. To adjust the ringer volume at the handset, see page 30.

Handset beeps

Are the handset batteries low? You will hear a beep every 30 seconds.

If the Base Station is flashing?

You will hear four short beeps when you press the PHONE button. Check you are still in range of your base station.

Buzzing noise on my Radio/TV/Answering Machine/PC

Diverse is too close and is causing interference. Move it further away.

Please note

If you are still experiencing

difficulty, please call the Diverse Helpline on 08457 908070.

44

Image 48

Contents User Guide Diverse 3000 foldout 1 22/3/01 206 pm Diverse 3000 foldout 2 22/3/01 206 pm At a glance NumberScroll backwards Confirm OK Scroll forwards Diverse 3000 Hset & Charger 22/3/01 153 pm Using your Diverse Classic Handset This guideQuick Reference Handset Display EXT INTInformation for the handset settings Quick GuideIntroduction Unpacking your Diverse 3000 Classic handsetSafety information CleaningGeneral EnvironmentalApproved rechargeable batteries Setting up Install the rechargeable Batteries in the handsetSlide battery cover down and lift off Connect the power cableBattery low warning To register your new Handset to the base station Press the SET buttonPress the OK Button. The flashes Station. The stops flashingFitting the belt clip Fit the belt clip onto the back of the handsetPlease remove Protective film from the display Using your Diverse 3000 Classic Handset To switch the handset on and offTo switch the keypad lock on and off Press and hold the #Making and receiving calls To make an external call To end a callTo call another handset To call all handsetsCall timer Press the button. Display shows the last number dialledTo redial any of the last 5 external numbers To delete the redial memory Secrecy Press the Recall button to speak to your caller againTo transfer an external caller to another handset During a callHold To receive an internal callUsing the memory to store and dial numbers Handset must be switched on Press the SET buttonTo store a number in the memory Press the OK button, enter your new numberTo speed dial a stored number Security features To delete all memory numbersTo change the handset PIN To lock and unlock the handset To switch external dialling off and on Enter the number of the handset you want to disablePress the 2 button to Allow the handset toPress the SET button Press the 0 button Press the 2 button Press the OK buttonMy additional emergency numbers are To dial your additional emergency numbersDirectory for barred/enabled numbers Call barring and Call enablingPress the OK button. Display shows the first location Using Caller Display and Call Waiting BT’s Caller Display and Call WaitingTo take the Call Waiting On hold. You can useUsing the Classic handset Information displayed via other UK networksTo view the calls list To dial a number in the calls list To delete the calls list Additional features Press the SET button MNO Press the 6 button. YouYou hear the melody MelodyTo adjust the earpiece volume To switch the handset button beeps on and offIf the battery is exhausted Level you wantTo switch music on hold on or off To switch the base station display in the handset on/offDEFPress the 3 button Press the SET button Press the 1 buttonTo switch auto talk on and off Press the 7 buttonTo change between base stations Press the SET button INT Press the INT buttonTo set your handset to priority base station selection To reset the handset to its original settings Handset PIN Registration to the base stationCall allocation Handset ringer tone to Ring priorityDEF ABC To set the number of rings on ring priority Using your Diverse 3000 Classic with a switchboard It is possible to set Tone with To insert an access code To set the access pause Guarantee Conditions of this guarantee areWithin the 12-month guarantee period Outside the 12-month guarantee periodSwitchboard external line access code Technical informationHow many telephones can you have? Help Emergency callsNo dial tone Wall mounting Index HandsetTransfer to another handset Offices worldwide