Cobra Electronics C P - 7 2 0 owner manual Wall Mounting Using Your Cobra, Intenna Cordless Phone

		WALL MOUNTING			USING YOUR COBRA
		On A Plate			INTENNA CORDLESS PHONE
		Your Cobra Intenna is designed to be used			Now that the handset batteries have
		with AT&T, GTE or any other wall-mounting		2
					charged overnight (at least 12 hours) your
		plates that may be purchased from most
					Cobra Intenna Cordless Phone is ready to
		local electronics or home repair stores.
					use.
			1. Press the telephone cord into the slots
			under the base and wrap it around the			To Answer A Call At The
			cord storage area as shown.
						Base
			2. Plug the phone connector into the		2
						When the phone rings, simply pick up
			telephone wall jack.
			3. Plug the power adapter into the		TALK	the handset from the base and the
						TALK button will automatically light.
			telephone base and a nearby AC
						When you hang up, it disconnects.
			power outlet.
			4.To hang the phone base, simply align
			the holes on the bottom of the base			To Place A Call At The Base
			with the studs on the wall plate and		2
			slide the base down until it locks into			Pick up the handset from the base,
			place.		TALK	then press and release the TALK button.
		1	5. Pull cradle hook to correct position to			When you hear the dial tone, place your		9
			hold handset.			call.
		CRADLE
		HOOK
		Directly On The Wall				To Answer or Place A Call
		To install the base directly on any wall, you’ll
						Away From The Base
		need two screws and wall anchors (not			2
		included).				The TALK button must be off (not lit)
					TALK	when the handset is away from the
			1. Drill two holes aligned vertically, one			base and not in use. Press and release
			31⁄4" higher than the other, and insert			the TALK button and, when your
			the wall anchors.			conversation is finished, press the TALK
			2. Drive the screws into the anchors until			button again to disconnect. If you
						replace the handset in the base, the
			the head of each screw sticks out
						TALK button will disconnect
1			about 1⁄8" from the wall.
						automatically.
			3. Plug the phone connector into the
			telephone wall jack.			To Answer A Call
			4. Plug the power adapter into the			At The Base Using
			telephone base and a nearby AC		3	The Speakerphone
			power outlet.			Press the SPEAKERPHONE button. See
			5. To hang the phone base, simply align
					SPEAKER-	page 13 for details.
			the holes on the bottom of the base		PHONE
			with the screws on the wall and slide		3
			the base down until it locks into place.
		1	6. Pull cradle hook to correct position to
			hold handset
Cobra	®	CRADLE
		HOOK			NEED HELP?		1-773-889-3087
CP-720