PYLE Audio PDWM4400 operation manual VHF Wireless System

Page 2

A.Overall system

 

 

Oscillation mode:

Quartz controlled

Carrier Frequency Range:

VHF 169-270MHz

Stability:

0.005%

Max Deviation:

56KHz with level limiting

Dynamic Range:

100dB

S/N Ratio:

80dB

T.H.D:

0.5%

Squelch:

"Pilotone & Noise lock" dual squelch circuit

Frequency Response:

100Hz~15KHz

Operating range:

Up to 240 Feet

B. Receiver

 

 

Sensitivity:

6dB

V at S/N>90dB

Image Rejection:

>60dB

Stability:

>80dB

Audio output:

-12db/600ohms unbalanced and balanced

Power supply:

15VDC/0.5A

Dimensions:

16.5

8.2 1.8 inch

C. Transmitter

Condenser Microphone(Headset mic/clip-on mic)

Mike capsule:

Antenna:

External

RF Output:

<10mW

Spurious:

<-40dB

Battery:

one 9V battery

8

VHF WIRELESS SYSTEM

OPERATION MANUAL

Thank you for buying the PDWM4400 Wireless System. Please read through these operation instructions so you will know how to operate your model properly. After you read it, put it away in a safe place for future reference.

Precautions

System diagram

Bodypack transmitter

Receiver Front panel

Receiver Rear Panel

Installation

Trouble shooting

Specifications

*Avoid exposure of the system to rain or moisture.

*No user-serviceable parts inside the system. Refer all servicing to a qualified technician only.

*Handle the wireless system carefully, dropping or other shocks may cause failure.

*Avoid using the system where it may be subjected to heat, such as direct sunlight, near radiators or other heat sources.

*Should any liquid be spilt on the system, stop using it immediately. It may be possible to dry the system, but you should have it checked by a qualified technician before using it again.

*Take care with the main power adapter and lead. If damaged in any way, do not use the system and refer to a qualified technician for repair.

*Only use the system with the supplied components. Do not attempt to use with any

*other main power supply adapter .

*If the wireless system is not going to be used for a while, remove the battery to prevent leakage. In the event of electrolyte leakage inside the battery compartment, carefully remove the leakage with a damp cloth. Take care not to get battery electrolyte in contact with your skin, however if it does, wash your hands under a running tap. If electrolyte comes into contact with your eyes, seek medical advice immediately.

*Only replace the battery with the same or an equivalent type.

*Please dispose of old batteries in an environmentally friendly manner in accordance with the relevant legislation.

*Do not use any solvents to clean any part of the wireless system .

Image 2
Contents PDWM4400 VHF Wireless System Channel Power Audio Output Jack Volume Switch Belt Clip Battery Cover Front Panel