http://koss.com/koss/kossweb.nsf/pmbyunid/695B97328E3F9565862567...
Close This Window
Congratulations on your choice of the Koss JR/900 Cordless RF Stereophone System. Now you can enjoy the Sound of Koss anywhere in your home- even
1.KossJR/900S Stereophones (1)
2.Koss JR/900T Transmitter (1)
3.Koss JR/900A Adapter (1)
4.3.5 mm male stereo plug to dual RCA stereo plug connecting cord.
5.DC male to DC male recharge cord
6.Adapter plug
7.3.5mm Stereo Jack
8.NICAD Battery Pack
IMPORTANT INFORMATION. READ BEFORE USING!
Located on the side of the transmitter is a charger output jack that is used to recharge the internal battery of the JR/900RF System
The NICAD(nickel cadmium) battery pack of the JR/900 must be fully charged prior to operation. An initial charge of 24 hours is required to ensure the extended life of the NICAD battery pack. Be sure the stereophone is in the "OFF" position. (SEE "To recharge the NICAD battery pack")
JR/900 OPERATING CONTROLS Volume Control
Controls the level of the audio signal input to the transmitter. Adjust for the highest
ON/OFF Switch
Place this switch in the ON position when using the stereophones. The ON indicator will be red. Place this switch in the OFF position when you are charging the battery or when the stereophones are not in use NOTE: When the ON/OFF switch is in the ON position, the on indicator light will light even when recharging is necessary.
Red LED/ Green LED
Red indicates the transmitter is operating. Green indicates the transmitter is charging when connected to stereophones.
Recharge Jack
The charger cable plugs into the transmitter at the charger input jack and the stereophones' charger cable input jack. This connection is made only when recharging the battery pack ( SEE " To recharge the NICAD battery pack")
Left/ Right RCA input Jack
Use dual RCA connecting cord (#4) to connect transmitter to the audio output.
AC Input
Connects 24VDC, 150mA ac adapter to transmitter.
Channel Selector
The channel selector is
1 of 4 | 9/29/2011 10:40 AM |