Motorola MOTO-L802, L804 No ring tone, Caller ID does not work, Phonebook entry cannot be stored

Page 27

No ring tone

•The ringer may be off.

•The volume may need to be increased.

Caller ID does not work

•Check your subscription with your network operator.

•If you subscribe to high-speed internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

A phonebook entry cannot be stored

• The phonebook is full. Delete an entry to free memory

No display

•Try recharging or replacing the rechargeable battery pack.

•Reset the base. Unplug the unit's electrical, then plug it back in.

•If the LED is not lit up, then try to unplug the unit's electrical power, and then plug it back in.

If the handset disconnects from the base during a phone call

•Check that the power cord is connected properly into the base.

•Check that the power adapter is connected properly into the electrical outlet.

•Move the handset closer to the base. It may be out of range.

•Reset the base by unplugging the unit's electrical power. Reset the handset by unplugging and re-plugging its battery pack. Wait for around 15 seconds and re-plug the power again. Allow up to one minute for the handset to synchronize with the registered base again.

Noise interference on your radio or television

•Your base or charger may be too close. Move it as far away as possible.

Help	27

Image 27

Contents User’s Guide US and Canada To your new Motorola PhoneGot everything? Getting started Getting to know your phone Using the PhoneHelp General information Setting up Getting startedLocation Wall mounting on the base Connecting the baseSetting the display language Installing and charging the handset battery packYour phone is now ready for use Setting the date and timeGetting to know your phone Overview of your cordless handsetMenu / editing mode Press to confirm and save the settings During message playback Press skip to play the next messageDuring message playback Press to stop playing messages Answering machine mode Press to delete the current message Idle mode / during a call Press to access the phonebookDuring an incoming call Press to answer a call Display Icons Cordless Handset LCD displayOverview of the base Base LED IndicatorsUsing the Phone Adding an entry to the phonebook Muting a callDialing from the redial list Dialing from the calls listCaller ID Calls ListViewing the calls list Saving a number from the calls list to the phonebook Deleting a calls list entryDeleting the entire calls list Menu map Personal SettingsIntercom Calling another handsetTransferring a call to another handset Setting the dial mode Setting the flash timeThree-party conference call Setting the area code Resetting all settingsRegistration Turning on or off the answering machine Using your answering machinePaging/Finding a handset Playing messagesRecording the announcementt Setting the announcement modeSetting the number of rings Announcement Playing the announcement Recording a memo Call screening on/off Remote access Turn the remote access on/offDeleting all old messages Poor audio quality Setting the security codeHelp No dial toneNo display No ring toneCaller ID does not work Phonebook entry cannot be storedImportant safety instructions General informationIf your product is not working properly Unplug this cordless phone immediately from an outlet if Installation GuidelinesWho is covered? Battery Safety InstructionsConsumer Products and Accessories Limited Warranty Warranty What Does this Warranty Cover?What Other Limitations Are There? What will Binatone do?Exclusions How to Obtain Warranty Service or Other Information? FCC, Acta and IC regulationsFCC Part FCC Part 68 and Acta General information Industry Canada Technical Specifications Motorola Mobility, Inc. All rights reserved Version