Installation
10
Do not expose the base station and charger unit to direct sunlight. Do not allow the base station and charger unit to become wet. They should not be set up in rooms which are subject to condensation or corrosive steam or a high concentration of dust (e.g. cellars, garages or conservatories). The room temperature must be between 00C and 350C.
Connecting the Base Station and Mains Adaptor
Insert the plug in the corresponding socket of the base station (it is not possible to mix them up as the socket and plug are designed to be
The base station does not have a power switch. Make
sure that there is a mains socket nearby and that the mains adaptor is easily accessible. Check that the voltage indicated on the mains adaptor corresponds
to that of your mains current.
Connecting the Charger Unit
Insert the plug of the mains adaptor in the socket on the underneath of the charger unit.
Plug the mains adaptor into the mains socket. The charger unit is now ready to use.
Inserting the Batteries
Open the battery compartment by pushing downwards
on the battery compartment cover. Insert
The mobile handset will not operate if the batteries
are inserted incorrectly. There is also a possibility 
that the handset may be damaged thereby.
Replace the cover on the battery compartment and push it upwards 
until it clicks into place. Place the handset in the base station.
A confirmation beep and the charging indicator confirm that charging has begun.
Note: When used for the first time, allow the batteries to charge for at least 14 hours without interruption. If possible, only take the handset out of the base station when
the charging process has ended. This will help to guarantee optimum operation.
Note: To ensure the battery charging properly, clean the charging contacts on the handset and charger with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or high humidity.
Installation
9