Memorex MPH6935 owner manual Mounting the base unit on a wall, Standard wall plate mounting

Page 33

MPH6935_OM Eng 3/12/02 3:08 PM Page 33

Additional Information (continued)

Mounting the base unit on a wall

Standard wall plate mounting

This phone can be mounted on any standard telephone wall plate.

5

2

5

4

3 1

1 Plug the telephone line cord to the TEL LINE jack and the AC adapter to the DC IN 9V jack.

2 Plug the telephone line cord into the telephone outlet.

3 Place the AC adapter cord inside the molded wiring channel.

4 Plug the AC adapter into a standard

120V AC wall outlet.

Note Use only the AC adapter supplied with this phone.

5 Align the mounting slots on the base with the mounting posts on the wall. Push in and down until the phone is firmly seated.

[Direct wall plate mounting]

If you don't have a standard wall plate, you can mount your phone directly to the wall. Before doing this, consider the following:

•Avoid electrical cables, pipes, or other items behind the mounting location. That could cause a hazard when inserting screws into the wall.

•Try to mount your phone within 5 feet of a working phone jack to avoid excessive cord lengths.

•Make sure the wall material is capable of supporting the weight of the base and handset.

•Use #10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the wall material where the base unit will be placed.

1 Insert two mounting screws into the wall, (with their appropriate anchoring device), 3-15/16 inches apart. Allow about 1/8 of an inch between the wall and screw heads for mounting the phone.

2 Refer to steps 1 through 5 above to mount the telephone.

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents
Introduction FeaturesControl and Functions Table of Contents Important safety instructions Cordless telephone privacy Additional battery safety precautionsImportant electrical considerations Telephone Line ProblemsFCC Wants You To Know RangeMore Than One Cordless Telephone Radio Interference10 to Read This First13 to About the digital security codeStep Checking the package contentsChoose the best location Setting up the base unitSurge Protectors Connect the base unitTip Choose the dialing modePreparing the battery pack Battery use time per charge When the battery charge becomes lowCleaning the battery contacts Making Calls Dialing from talk modeDialing from standby RedialingAny key when ringing Instant Talk when ringingReceiving Calls Receiving a callHandset Ringer and Earpiece Volume Using the Page FeatureTo locate the handset while it’s off the base Storing phone numbers and names Memory StoringAfter about 2 seconds, Memory Store is displayed If you make a mistake while entering a name Steps for entering names and special charactersMemory Dialing Making calls with memory dialingDialing from standby Display a Programmed Number Dialing from talk modeEditing a stored name and/or phone number Memory EditingErasing a stored name and phone number Memory ErasingStoring and Editing the Speed Dial Speed Dial FeatureMaking calls with speed dialing Deleting the Speed DialCaller ID Features Setting Caller ID options/LanguageCaller ID When the telephone rings Viewing the Caller ID message list Long Distance Calls and Area Code Setting/Cancellation Deleting information from the Caller ID list Deleting a Caller ID message Deleting all Caller ID names/numbers Using the Caller ID list Storing Caller ID messages in MemoryCalling a party from the Caller ID list Using Caller ID with Call Waiting service Changing the digital security code Additional InformationMounting the base unit on a wall Standard wall plate mountingDirect wall plate mounting Battery replacement and handling MaintenancePower Failure Ni-CdSymptom Suggestion TroubleshootingAdditional Information Storing the data IndexLimited WARRANTY-CORDLESS Telephones Memo UCZZ01373BZ
Top Page Image Contents