Topcom 9100 user manual Getting started, Charging batteries, Removing/Installing the Belt Clip

Topcom Twintalker 9100

8 Getting started

8.1Removing/Installing the Belt Clip

1.To remove the clip from the unit, push the belt clip (B) towards the antenna, while pulling the clip tab (A).

2.When re-installing the belt clip, a click indicates the belt clip is locked into position.

8.2Battery Installation

1.Remove the belt clip (§ 8.1).

2.Open the locking latch (C) and slide off the battery cover.

3.Install the rechargeable battery pack following the polarity as shown. Ensure that the metal contacts on the side (D) are facing outwards from the radio to connect on the battery door.

4.Re-install the Battery Cover and Belt Clip (§ 8.1).

A

B

C

D

9 Charging batteries

When battery packs are installed, the desktop charger provides drop-in charging conveniency

1.Put the desktop charger on a flat surface.

2.Plug one end of the supplied

adapter into the electric socket and the other end into the connector on the backside of the desktop charger.

3. Put the radio in the charger as indicated.

4.The charging LED will turn on if

it’s properly inserted and charging.

It will take about 8 to 10 hours to fully charge the batteries

Do not short-circuit & dispose of in fire. Remove the batteries if this device is not going to be used for a long period.

6 Topcom Twintalker 9100