Topcom Butler 2511 Deluxe
if your handset is another model
After starting the registration procedure on the base, refer to the handset manual to find out how to register the handset. The handset must be GAP compatible.
The icon 
and the text "NOT REG" flashes on the display when the handset is not associated with the base.
When a handset is associated with a base, it is attributed a handset number by the base. It is this number that is displayed on the handset after the name and must be used for internal calls.
6.2 REMOVING A HANDSET
You can remove a handset with a base to allow another handset to be registered
1.Enter the menu by pressing 
/OK
2.Select setup using the up 
and down 
keys
3.Press OK
4.Select del hs using the up 
and down 
keys
5.Press OK
6.Enter the 4 digit base PIN code
7.Press OK
8.Select the handset to be removed
9.Press OK to validate
6.3 SETTING UP A HANDSET ON ANOTHER BASE
If you want to use a Butler 2511 Deluxe handset with a base of another model. The base must be GAP compatible.
1.To put the base in registration mode, refer to the base user manual.
2.Carry out operations 3 to 9 from the paragraph 6.1.
6.4 SUBSCRIBING A TOPCOM BUTLER 300 DECT GAP HEADSET
Make sure that the base 
of the base for 6 seconds.
The base will then emit a beeptone. During this minute, the base unit is in subscribing mode and you must do the following to subscribe the headset:
-Turn ON the headset by pressing the ON/OFF button until you hear two beep tones. At the same time the red and green LED will lit ones.
-Remove the rubber cover of the power socket so that the hole of the power socket is free. Pull out the rubber cover from the headset so that the registration key hole is free also.
-Press the headset registration key. The red LED will flash rapidly.
-If after a few seconds the green LED flashes slowly, the registration is successful.
-If the red LED flashes slowly, the registration is failed. Repeat above procedure and make sure that the base
20 | Topcom Butler 2511 Deluxe |