Topcom Butler 2511 Deluxe
Setting the pause duration
1.Enter the menu by pressing 
/OK
2.Select Setup using the up 
and down 
keys
3.Press OK
4.Select PABX using the up 
and down 
keys
5.Press OK
6.Select PAUSE using the up 
and down 
keys
7.Press OK
8.Select the PAUSE time using the up 
and down 
keys
9.Press OK to validate
6. MANAGING MULTIPLE HANDSETS
6.1. SETTING UP AN ADDITIONAL HANDSET
You can subscribe new handsets on the base if these handsets support the DECT GAP protocol.
The base can support a maximum of 5 handsets. If you already have 5 handsets, and you wish to add another one or change one handset, you must first delete a handset, then associate the new handset.
To register any handset, the base must be put into a special registration mode:
1.Press and hold the paging key 
of the base for 6 seconds.
2.The base will then emit a beeptone. The base is now ready to register a new handset. You have 90 seconds after pressing the button to register a new handset.
After putting the base into registration mode, start the procedure on the new handset:
if your additional handset is a Butler 2511C Deluxe
3.Enter the menu by pressing 
/OK
4.Select Register using the up 
and down 
keys
5.Press OK
6.Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.
7.Enter the Base PIN code (0000 by default )
8.Press OK. The handset will start searching for the DECT base
9.If the handset has located the base, it will display the base identification number, validate the
base registration by pressing OK or stop by pressing 
,
10.If the handset does not locate the base, it will return to the standby mode after a few seconds.
Try again by changing the base number and check that you are not in a environment where there is interference. Move closer to the base.
ENGLISH
Topcom Butler 2511 Deluxe | 19 |