Telephone Operation

GX2400 English I/B ver. 09020A-1

NOTE: Default mode is ringer on mode. RING OFF LED indicator is off.

1.Press and hold RING on/off button for about 2 seconds to set ringer off mode. RING OFF LED indicator is on.

2.In ringer off mode, press and hold RING on/off button for about 2 seconds to set ringer on mode. RING OFF LED indicator is off.

TO PLACE A CALL

1.Press the TALK button on the handset. The handset IN USE LED indicator will flash while the unit auto-scans and will light steadily when it finds a clear channel. A confirmation tone is heard once there is a link between the base and handset. The base IN USE LED indicator will also light steadily when the handset is in use.

2.Listen for a dial tone.

3.Dial the telephone number.

4.When finished with your call, press the TALK button or place the handset on the base unit. The base IN USE indicator will turn off.

TO RECEIVE A CALL

NOTE: If you are expecting incoming calls, the ringer mode must be set to RING ON mode. RING OFF LED indicator is off.

A.IF THE HANDSET IS ON THE BASE UNIT

1.Since the GX2400 features “ Auto-Answer “, simply pick up the handset from the base cradle when the phone rings. The base and handset IN USE LED indicator will turn on.

2.Start your conversation.

3.To end your conversation, either press the TALK button or place the handset on the base unit. The base IN USE LED indicator will turn off.

B.IF THE HANDSET IS OUT OF THE BASE UNIT

1.When the phone rings, press the TALK button on the handset. The unit will scan for a clear channel until the IN USE LED indicator lights up and a confirmation tone is heard.

2.Start your conversation.

3.To end your conversation, either press the TALK button or place the handset on the base unit. The base IN USE LED indicator will turn off.

LAST NUMBER REDIAL

A.AFTER HEARING A BUSY TONE WHEN PLACING A CALL

1.If you get a busy tone, press handset TALK button to hang up.

2.Press the handset TALK button again and listen for a dial tone.

3.Press the handset RE/PA button. This will automatically redial the last telephone number you called (Up to 24 digits).

B.WHEN THE HANDSET IS OFF THE BASE UNIT AND IN STANDBY MODE

1.Press the TALK button on the handset and listen for a dial tone.

2.Press the RE/PA button. This will automatically redial the last telephone number you called (Up to 24 digits).

NOTE: When the adapter power is disconnected and connected again, the unit cannot redial the last telephone number you called.

MEMORY DIALING

You can store up to 10 telephone numbers (up to 16 digits each) into memory and you can then dial any of the stored phone numbers.

A.STORING TELEPHONE NUMBERS INTO MEMORY

1.Make sure that the handset is in the standby mode. The base and handset IN USE LED indicator should be OFF.

2.Press and release the MEMO button. The handset will beep once.

3.Enter the telephone number you want to store (maximum of 16 digits). A key tone is heard for every key pressed.

4.Press the MEMO button once again.

09020A-1

OWNER’S MANUAL#GX2400VER. 09020A-1

PAGE: 11 U.S. English Version