Audiovox gx2400 owner manual Improving Cordless Reception, Maximizing Battery Life, Maintenance

GX2400 English I/B ver. 09020A-1

LOW BATTERY WARNING

∙When the handset battery voltage level is low, the handset will beep every 8 minutes and the handset BATT LOW LED indicator will flash in talk mode.

∙In standby mode, the handset BATT LOW LED indicator will flash.

∙Return the handset on the base cradle to charge.

PAGING FUNCTION

∙Press the PAGE button on the base unit. The page tone will be heard on the handset. The handset IN-USE LED indicator will flash indicating the paging period. Page is also useful to help locate a misplaced handset.

RESETTING THE SECURITY CODE AND CHANNEL INFORMATION Communication between the handset and base unit may not be possible in any of the following situation:

∙After a power failure.

∙After relocating the base unit by disconnecting the adapter.

∙After replacing the handset battery.

To reset, place the handset on the charge cradle of the base unit for 5 seconds.

IMPROVING CORDLESS RECEPTION

Follow these guidelines to improve cordless sound quality:

∙Select an area to install the GX2400 where it is closest to the center of your home or office. This will improve the operating range of the unit.

∙Keep the GX2400 base unit away from electrical equipment. Radio Frequency Interference (RFI) is sometimes generated by these appliances, which can cause degradation in cordless reception.

∙Keep the handset batteries charged as much as possible. Weak handset batteries can limit the range of cordless operation.

MAXIMIZING BATTERY LIFE

Repeated use or recharge of Ni-Cd batteries without periodic full discharge results in reduced useable charge time. When you notice the usable charge duration decreasing, fully discharge the Ni-Cd battery and recharge as described:

DISCHARGING

1.Unplug the telephone line cord from the GX2400.

2.Make sure that the adapter is connected.

3.Lift the handset out of the base cradle.

4.Press the TALK button of the handset (IN USE LED indicator should light) and start discharging.

Once the BATT LOW LED indicator starts flashing, it means that the battery level is low. Let it fully discharge for 12 hours. Once the Ni-Cd battery is fully discharged, you may now charge the battery to its full capacity.

CHARGING

1.Make sure the adapter and telephone line cord are connected to the GX2400.

2.Place the handset on the base cradle. The CHARGE LED indicator of the base unit will light steadily.

3.Leave the handset charging on the base for 14 hours continuously to get a maximum charge.

4.The GX2400 is now ready for regular use. Discharge and charge the Ni-Cd battery again once you notice a decrease in the useable charge time.

MAINTENANCE

1.Your phone should be situated away from heat sources such as radiators, heaters, stoves or any other appliance that produces heat.

2.Use a slightly damp cloth to clean the plastic cabinet. A mild soap will help to remove grease or oil. Never use polish, solvents, abrasives or strong detergents since these can damage the finish.

13 09020A-1

OWNER’S MANUAL#GX2400VER. 09020A-1

PAGE: 13 U.S. English Version