Installing a Replacement Battery

Remove the existing battery and unplug the connector from the jack.

UU438DH_ENG.fm Page 9 Monday, June 13, 2005 7:00 PM

Follow the steps if you need to replace a battery.

1 Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove.

3 Plug the battery pack connector (red, black, and white wires) into the jack inside the battery compartment. (The connector notches fit into the grooves of the jack only one-way.) Match the wire colors to the polarity label in the battery compartment, and push the connector in until you hear a click.

4 Make sure you have a good connection by slightly pulling on the battery wires. If the connection is secure, the battery jack will remain in place.

5 Place the battery case cover back on

the handset by sliding it upwards until it clicks into place.

Notes:

•Use only the SANYO battery (BT-0001) supplied with your phone.

•Don't place the charger in direct sunlight or subject it to high temperatures. The battery may not charge properly.

Rechargeable Lithium Ion Batteries

Must Be Recycled or Disposed of Properly

– E9 –