Additional Notes, Troubleshooting Guide

SC3130 User Guide

RING/HOLD key again.

FLASH key (600ms)

In the on-hook mode, press this key to auto-hang up for 600ms, after that you can press REDIAL key or dial out another number.

REDIAL/BACK key

In the on-hook mode, pre-dial the number then press REDIAL/BACK key to auto pick up and dial out the number. In the off-hook mode, press this key to redial the last dialed number. When checking the incoming number or outgoing number, press REDIAL/BACK key to auto pick up and dial out the number directly.

HF (HANDSFREE) key

While on-hook, press the HF key to go into handsfree mode. You can talk through the microphone and listen from the speakerphone without lifting the handset. While off-hook, press the HF key and put down the handset to go into handsfree mode.

5. ADDITIONAL NOTES

INCOMING CALL LCD INDICATOR

When there is incoming call, the unit will be automatically display the caller number, date and time, and also display its serial number. If the incoming call is in private mode, it will display “__p__”; it will display “__0__” if exchange cannot determine the number; it will display “—E—“ if the call signal contains error.

LCD BACKLIGHT FUNCTION

When there is incoming call or handset is off-hook, the LCD backlight will lit up. It will be on for about 6 seconds before going off. Without batteries, LCD backlight will not lit up at all.

TROUBLESHOOTING GUIDE

(Q) I do not hear any dial tone from the handset.

(A)Ensure the handset cord is connected correctly from the handset to the handset cord jack at the base. Ensure you have plug in the telephone cable from the telephone to the wall socket correctly. If the problem persists, please check with your local dealer.

(Q) I could not see the caller’s number on the LCD when there is incoming call.

(A) Ensure that you have subscribed Caller ID service from your local telecom provider.

(Q)There is no LCD Display / Backlight after I have connected the telephone line. I can call out normally.

(A)Ensure that you have inserted the batteries on the battery compartment. If there is still no display, change the batteries and ensure it is not empty. If the problem persists, please