Shiro SD8501 user manual Installation, Choose a suitable site for the base unit

Page 7

User Manual

Installation

1.Choose a suitable site for the base unit

Make sure it is not near to another telephone, nor to other electrical equipment.

2.Plug the mains power lead and the telephone line cord into the rear of the base unit

3.Plug the mains adapter into a 230 V AC, 50 Hz mains socket, with the switch on the socket set to OFF

Note: The illustration of adaptor may vary from country to country.

4.Switch on mains power at the socket

5.Fit the batteries in the handset(s)

Insert the rechargeable batteries following the batteries polarity indication.

Fit the batteries compartment cover, Sliding it until it clicks firmly into Position.

6

Image 7

Contents SD8501 Contents What the symbols mean Handset and Base Unit How many phones can you connect? Setting up your telephoneRadio signals between handset and base unit Connection and conditions for useWhats in this pack Choose a suitable site for the base unit InstallationPage Important safety information Warranty Information Making and answering calls Delete Phone BookTo clear a number from phonebook To modify change a number in phonebookTo save a number in call logs Call LogsTo clear all numbers from phonebook To check call recordsKey tone on and off Handset SettingRinger Volume EXT Ringer Volume INTEXT Ring Ringer Melody INTYour handset name Display languageBase Setting Base Melody Base VolumeVolume To delete call barring numberPabx function To Set Dial ModeFlash function To change base PIN Resetting the systemTo make an intercom call Handset registrationIntercom and transfer To register a handsetTo transfer the outside call to another outside phone TroubleshootingPhone does not ring Handset’s batteries is running low within an hour or two Technical detailsDeclaration of conformity