4.Repeatedly press SKIP or REPEAT to set the second digit, then press STOP. The third digit appears.
5.Repeatedly press SKIP or REPEAT to set the third digit, then press STOP. The TAD sounds a long beep then announces and displays the new CBT code.
CHANGING THE REMOTE OPERATION SECURITY CODE
The TAD’s remote operation security code is preset to 798, but you can change it by following these steps.
Note: If you do not complete each step within 8 seconds, the TAD sounds four beeps and exits setup. Start again from Step 1.
1.Hold down CODE (Co appears) until the TAD beeps once.
2.Press CODE again. Sc (security code) and the digits of the current code appear in sequence, then the first digit reappears.
For example, if the security code is
798, the message counter shows
Sc,
16
3.Repeatedly press SKIP or REPEAT to set the first digit, then press STOP. The second digit appears.
4.Repeatedly press SKIP or REPEAT to set the second digit, then press STOP. The third digit appears.
5.Repeatedly press SKIP or REPEAT to set the third digit, then press STOP. The TAD sounds a long beep then announces and displays the new security code.