VTech IP811 user manual Setup, Connecting Power to Handset Charger, Installation of Battery Pack

Page 6

Setup

Connecting Power to Handset Charger

Because the IP 811 is an accessory handset to the IP 8100-2/8100-3 all you need to do is choose the location for your handset charger and plug in the power supply into an electrical outlet.

CAUTION: Use only the VTech power supply provided with your telephone.

Installation of Battery Pack

1. Remove battery compartment cover by pressing on the indentation and sliding downward.

2. Place the new battery pack in the handset with the positive and negative poles aligned in the battery compartment.

3. Replace the battery pack cover by sliding it upwards.

4. If the new battery is not already charged, place the handset in its charger and allow it to charge for 10-12 hours.

5. After the initial charge, a maintenance charge of 10-12 hours should be suffi- cient. Be sure to place the handset in

its charger when not in use to insure maxi- mum daily performance.

6. Average talk time on a fully charged battery is about nine hours, standby time is approximately four days.

Getting Started

5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Accessory Handset Important Safety Instructions Important Safety Instructions Parts Check List Handset Layout Setup Connecting Power to Handset ChargerInstallation of Battery Pack Charging of the Handset Battery Checking for Dial ToneRegistration Description Handset IndicatorsHandset LEDs Handset IconsHeadset Operation Headset OperationMaintenance Phone Doesn’t Work At All Handset Does Not Ring When You Receive a CallCase Of Difficulty No Dial ToneHow long is the limited warranty period? Warranty StatementWhat does this limited warranty cover? What is not covered by this limited warranty?How do you get warranty service? Other LimitationsFCC, ACTA, and IC Regulations FCC PartIC Industry Canada FCC, ACTA, and IC Regulations Technical Specifications Nominal Effective RangeTable Of Contents Need HELP? Issue
Top Page Image Contents