VTech i 6773 manual Getting Started Setup, Installation of Battery, Connecting Power to Base Unit

Page 9

Getting Started

Setup

Connecting Power to Base Unit

CAUTION: Use only the VTech power supply provided with your telephone. Plug the power adapter into an electrical outlet not controlled by a wall switch, and the connector into the bottom of the base unit.

To telephone outlet

To power outlet

Installation of Battery

1. Remove battery compartment cover by pressing on the indentation and sliding downward.

2. Align the two holes in the plug with the socket pins, then snap the plug into place. Place the battery in the compartment with the wires in the upper right corner.

3. Replace the battery cover by sliding it upwards.

4. If the new battery is not already charged, place the handset in its base or charger and allow it to charge for 10-12 hours. After the initial charge, a maintenance charge of 10 hours should be sufficient. Be sure to place the handset in its base when not in use to insure maximum daily performance.

6

Image 9

Contents Need HELP? Table Of Contents Advanced Operation Important Safety Instructions Vtech Communications INC Parts Check List Handset Layout 13 12 11 Base Unit LayoutGetting Started Setup Installation of BatteryConnecting Power to Base Unit Getting Started Charging of the Handset BatteryGetting Started Wall Mounting Basic Operation Handset and Base IndicatorsHandset Icons Description Handset LEDBasic Operation Handset Operation Temporary ringer adjustments Mute FunctionIntercom Call Call Forward Conference CallBase Operation Storing a New Entry Phonebook OperationReviewing/Dialing from the Phonebook Delete a Phonebook Entry Editing a Phonebook EntryBasic Operation Call Log Caller ID Call Waiting Reviewing Caller IDCaller ID Call Waiting ID Dialing from Caller ID Storing a Caller IDDeleting Caller ID Ringer Volume Handset SettingsKey Tone preset to on Ringer ToneBasic Operation Handset Settings Language preset to EnglishDial Type preset to Tone Answering System Operation Audible IndicatorsTurn Answering System On or Off Set the ClockAbout Mailboxes About AnnouncementsRecord Your Announcement Answering System Feature Setup Review Your AnnouncementDelete Your Announcement Default setting indicated by System OperationToll saver Listen to Messages Adjust Playback Volume Delete Messages Delete a Specific MessageDelete All Messages in a Mailbox Call Screening Record a MemoFlashing Counting 1 toSteady for one second 40-99Voice Menu Remote AccessBelt Clip Headset OperationAdditional Information Case Of DifficultyYour answering system is not recording messages Common cure for electronic equipmentYou cannot hear recorded messages CL is flashing in the base Message Window DisplayMaintenance What does this limited warranty cover? Additional Information Warranty StatementHow long is the limited warranty period? What is not covered by this limited warranty?Other Limitations How do you get warranty service?FCC Part Additional Information FCC, Acta and IC RegulationsConnection and use with the nationwide telephone network Product identifier and REN informationRepair instructions Rights of the telephone companyProgramming/testing of emergency numbers Hearing aid compatibilityIC Industry Canada FCC, Acta and IC Regulations Nominal Effective Range Technical SpecificationsIndex Issued