ITAD OPERATION
4.The OGM replays the message automatically, followed by a beep.
5.To review a recorded announcement, press MENU key until the desired item (Set outgoing message) is announced. Press any MAILBOX key. The current greeting is played.
6.To delete a recorded announcement, press DELETE during OGM playback.
Note: If your recording time is less than 2 seconds, your OGM will not be recorded, and the default greeting will be used.
Set Security Code
The security code programmed into the ITAD is used to gain access to functions from remote locations.
The security code default setting is 19.
TIME/SET KEY
SELECT KEY
MENU KEY
1.Press MENU until you hear “Set security code.”
2.Press TIME/SET to hear the current security code.
3.Press SELECT briefly to increase the security code by 1. Or, hold SELECT continuously to increase the code by multiples of 10.
4.Press TIME/SET to confirm your choice and you will hear the announcement of the security code.
Day and Time Setup
During initial setup, or after a power failure, the day and time default is set to Monday 12:00am. The display will flash “CL” to indicate day and time need to be set.
TIME/SET KEY
SELECT KEY
MENU KEY
1.Press MENU until you hear, “Set day and time.”
2.Press SELECT until the desired day is announced.
3.Press TIME/SET to confirm your choice.
4.Press SELECT until the desired hour is announced.
5.Press TIME/SET to confirm your choice.
6.Press SELECT until the desired minute is announced. Holding the key continuously will increase the minute in 10 minute steps.
7.Press TIME/SET to confirm your choice. You will hear the Day and Time.
Set Audible Message Alert
If you want your ITAD to beep once ev- ery 10 seconds to notify you when new messages have been received, set the Audible Message Alert to ON. Otherwise, it is preset to OFF.
23