VTech VT 9155 important safety instructions Important Safety Instructions

Page 5

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:

1.Read and understand all instructions.

2.Follow all warnings and instructions marked on the product.

3.Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

4.Do not use this product near water (for example, near a bath tub, kitchen sink, or swimming pool).

5.Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.

6.Slots and openings in the cabinet and the back or bottom are provided for ventilation. To protect it from overheat- ing, these openings must not be blocked by placing the product on the bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation where proper ventilation is not provided.

7.This product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, consult your dealer or local power company.

8.Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking on it.

9.Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.

10.To reduce the risk of electric shock, do not disassemble this product. If service or repair work is required, contact VTech Customer Service at 1-800-595-9511in the U.S. and at 1-800-267-7377in Canada. Opening or removing cabinet parts other than specified access doors may expose you to dangerous voltages or other risks. Incorrect reassembling can cause electric shock when the appli- ance is subsequently used.

11.Do not overload wall outlets and extension cords as this can result in the risk of fire or electric shock.

12.Unplug this product from the wall outlet :

A. When the power supply cord or plug is damaged or frayed.

B. If liquid has been spilled into the product.

C. If the product has been exposed to rain or water.

D. If the product does not operate normally by following the operat- ing instructions. Adjust only those controls that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work to restore the product to normal operation.

E. If the product has been dropped and the cabinet has been damaged.

F. If the product exhibits a distinct change in performance.

13.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lighting.

14.Do not use the telephone to report a gas leak in the vicinity of the leak.

SAVETHESEINSTRUCTIONS

5

Image 5
Contents Table of Contents FCC and IC Regulations Technical Specifications Introduction Other special features areItad Features Parts Check List Important Safety Instructions Replacing the Handset Batteries If the Battery Pack DOESN’T RechargeSpare Battery Charger Rbrctm Seal To install the Spare Battery PackGetting Started SettingUpYourVTECHVT9151/VT9155Wall Mounting Handset Features Base Unit Features LED status What it means Base Unit DisplayPhone Operating InstructionsChecking The Ringer Temporary ToneTurning Off The Ringer Programming The Ringer Type Programming Speed Dial Numbers The handset must be OFF Memory DialingSpeed Number Dialing To Change or Replace a Speed Dial NumberStoring Special Codes Storing a Redial Number into Speed Dial Using RedialFeature Answer ON/OFF LED Itad Base LedsMailbox LED’s Answer ON/OFF KEY Itad Base Keypad FunctionsMailbox X 1,2 or 3 KEY REC / Memo KEYSelect KEY Menu KEYTIME/SET KEY SKIP/QUICK KEY Volume Down KEYItad Operation Set Audible Message Alert Day and Time SetupSet Security Code Set Number of Rings Set Announce OnlySet Base Ringer On/Off Leaving a Message Incoming Message Listening to Messages / MemosTurning the Itad ON/OFF Saving MessagesDeleting Messages Audible Current Day and Time Changing Speaker VolumeCall Screening Changing Playback Speed Power FailureAuto Disconnect for Extension Phone Pick-up Memory FullPlaying Messages Remotely Remote Operation of ItadRepeat Messages During Playback Skip Messages During PlaybackChange OGM Remotely Memo RecordingCheck OGM Remotely Turning Itad on or OFFInstallation OptionalheadsetinstallationandoperatinginstructionsCleaning your telephone MaintenanceTaking Care of Your TELE- Phone Avoid rough treatmentCase of Difficulty Warranty Statement United States FCC and IC RegulationsVtech Communications Canada Call Vtech Electronics atIC Industry Canada Technical Specifications 91-5055-30-00 IssueUSER’S Manual
Related manuals
Manual 44 pages 51.21 Kb