Getting Started | Setup |
|
|
Registration And Operation Of The VTECH
Your VTECH
L1 | OFF | L2 | |
FLASH | CLEAR |
| FLASH |
1 | 2 ABC | 3 | DEF |
4 GHI | 5 JKL | 6 | MNO |
7 PQRS | 8 TUV | 9 WXYZ | |
* TONE | 0 OPER | # |
|
HANDSFREE | INTERCOM/ |
| VOLUME |
| TRANSFER |
|
|
2.4GHz | GIGA PHONE | ||
Handset | Belt Clip | Battery Pack | Charger Unit |
Installation of Battery Pack in Handset
|
| Follow the steps below: | ||
1 |
| 1. | Remove the battery cover by pressing | |
3 | 2. | on the indent and sliding downward. | ||
| Place the new battery pack in the | |||
|
| |||
|
|
| handset with the metal contacts | |
|
|
| aligned with the charge contacts in | |
|
| 3. | the battery compartment. | |
|
| Replace the battery cover by sliding | ||
|
| 4. | it upwards. | |
|
| If the new battery pack is not already | ||
|
|
| charged, place the handset in the | |
|
|
| base unit, or a remote charging | |
|
|
| stand, and allow it to charge for 12 | |
|
|
| hours. | After initial charge, a |
| 2 |
| maintenance charge of 8 hours | |
|
| should be sufficient. | ||
1
3
5
L1 | OFF | L2 |
FLASH | CLEAR | FLASH |
12 ABC 
3 DEF
4 GHI | 5 JKL | 6 | MNO |
7 PQRS | 8 TUV | 9 WXYZ | |
* TONE | 0 OPER | # |
|
HANDSFREE INTERCOM/ VOLUME
TRANSFER
2.4GHz 
GIGAPHONE
Setup Of The VT20-2420 Accessory Handset
1. Plug the AC power adapter into an electrical outlet.
2. Remove the Handset battery cover by pressing on the indent and sliding downward.
3. Place the new battery pack in the Handset, with the metal contacts aligned with the charge contacts in the battery compartment.
4. Replace the battery cover by sliding it upward.
5. Place the Handset in the Charge Cradle, and allow it to charge for 12 hours. After the initial charge, a maintenance charge of 8 hours should be sufficient.
The original Handset that is shipped with you
As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, HANDSET 4, and so forth.
Whenever a Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset.
BEFORE USING YOUR HANDSET(S), CAREFULLY PEEL OFF THE PROTECTIVE FILM, COVERING THE DISPLAY.
4 | 5 |